Week 1: Assignment

AUG 29th Review:

I was assigned to the Small Scale Bogie Design Team. For now I will be the only one in this assigned team however I will be working closely with the small scale track team. Tasks were given at the end of class to create team blogs, begin research, and begin brainstorming ideas to present to the class for about five minutes. During a short introduction to the small scale bogie, Professor Furman introduced three main issues with the current bogie system. The first was that the motors would burn out after letting them run all day. Second the tires are worn out because no differential system is in place. Third, there is binding at the joint of the master and slave systems.

Comments

Post a Comment

Popular posts from this blog

Week 5: Presentation 1

SEPT. 26th 2018--Small Scale Bogie System Task Items: -Develop a thorough schedule including dates of assignments.  -Continue research. -Think of concepts. -Look more into specific design criteria. Summary: Today all teams presented their presentation regarding an overview of their project including their purpose, goals, functional specifications, and plans. In regards to the Small-scale bogie team's presentation, the necessity in preparing for future presentations is clear. Evaluation of presentation criteria will should be done earlier to allow adequate time to develop meaningful and organized content.  At the end of the Small-Scale Control team Professor Furman commented on the use of gimbal motors as an alternative to brush-less motors that provide high rpm. At the end of my presentation Furman relayed that the bogie design is a candidate for injection molding were the design geometry of the bogie will need to be reviewed in the future. Link to presentation: ...
Read more

Week 12: Design

NOV 14th - Small Scale Bogie Improvements Team Continuing from last weeks flanged wheel design, after increasing the angle to 25 degrees I was able to achieve passive turning. However, the dramatic increase of angle lead to excessive rocking back and fourth of the wheels. While not perfect the concept is proving feasible with more angles to be tested. Some concerns is that inconsistencies in the track may cause results to vary in some areas but with the small scale track team's efforts in improving the bending process the function of the wheels will most likely succeed. A comparison of pros and cons of using the wheels and differential is required for further development towards a final design. I received information from professor Furman and his guest that bricklink.com has a wide selection of Lego parts that will aid in gear selection to ensure functional gear trains for using bevel gears with the differential. Additionally, the small scale track team and I visited Daniel Bol...
Read more

Week 14: Presentations

In class presentations were given to which none of the small scale was able to present due to time constraint. From the Gantt Chart, this week marks the beginning of the FEA analysis for the bogie design. The main areas of concern will be the articulating joint and servo arm for track switching. Last years arm model was able to achieve a safety factor of 8.5 which should be similar to this years model as it is similar. However the linkage system will also have to go FEA to ensure that there is not failure at the joint where the parts are expected to have the least material. The articulating joint will go under similar analysis.
Read more