Week 8: Lecture

OCT. 17th 2018--Small Scale Bogie

Task Items:
-Continue developing concepts
-Create presentation

Summary:
For today we had two hours to work on our project before meeting on campus for a lecture. Within the two hours I researched some more design concepts and looked up presentation requirements. The design concepts developed so far resemble that of a car frame allowing space between rails for placement of the drive components. Typical bogies utilize an H-frame design and will influence further design.

 The lecture discussed the effects of technology and social interaction. We conducted a survey and discussed in groups what we put down. A few groups presented in which most agreed that technology has had an effect on social interaction. 

Comments

Post a Comment

Popular posts from this blog

Week 5: Presentation 1

SEPT. 26th 2018--Small Scale Bogie System Task Items: -Develop a thorough schedule including dates of assignments.  -Continue research. -Think of concepts. -Look more into specific design criteria. Summary: Today all teams presented their presentation regarding an overview of their project including their purpose, goals, functional specifications, and plans. In regards to the Small-scale bogie team's presentation, the necessity in preparing for future presentations is clear. Evaluation of presentation criteria will should be done earlier to allow adequate time to develop meaningful and organized content.  At the end of the Small-Scale Control team Professor Furman commented on the use of gimbal motors as an alternative to brush-less motors that provide high rpm. At the end of my presentation Furman relayed that the bogie design is a candidate for injection molding were the design geometry of the bogie will need to be reviewed in the future. Link to presentation: ...
Read more

Week 12: Design

NOV 14th - Small Scale Bogie Improvements Team Continuing from last weeks flanged wheel design, after increasing the angle to 25 degrees I was able to achieve passive turning. However, the dramatic increase of angle lead to excessive rocking back and fourth of the wheels. While not perfect the concept is proving feasible with more angles to be tested. Some concerns is that inconsistencies in the track may cause results to vary in some areas but with the small scale track team's efforts in improving the bending process the function of the wheels will most likely succeed. A comparison of pros and cons of using the wheels and differential is required for further development towards a final design. I received information from professor Furman and his guest that bricklink.com has a wide selection of Lego parts that will aid in gear selection to ensure functional gear trains for using bevel gears with the differential. Additionally, the small scale track team and I visited Daniel Bol...
Read more

Week 14: Presentations

In class presentations were given to which none of the small scale was able to present due to time constraint. From the Gantt Chart, this week marks the beginning of the FEA analysis for the bogie design. The main areas of concern will be the articulating joint and servo arm for track switching. Last years arm model was able to achieve a safety factor of 8.5 which should be similar to this years model as it is similar. However the linkage system will also have to go FEA to ensure that there is not failure at the joint where the parts are expected to have the least material. The articulating joint will go under similar analysis.
Read more